manual-rmp210-rmp3545-en-18
Page
8 / 16
Setup
The machine is delivered in a special wooden packaging. Please first check the condition of the
packaging upon receipt of the goods. Only acknowledge receipt of the goods by the forwarder as
okay if the packaging is in perfect condition. Otherwise this will endanger any claims to the transport
insurance.
If you notice damage only when unpacking the machine, please report them as concealed damage
also immediately in written from to the forwarder, your transport insurance and also to us.
To unpack the machine, first remove the side and top boards. The machine will then stand in front of
you on a pallet.
Only use suitable lifting and transport equipment such as forklift trucks or pallet trucks. Secure the
machine against slipping / tilting. Attention, high center of gravity!
Transport machine only vertical! Do not carry horizontal by any means!
The machine must stand level and there should be sufficient space for operation and maintenance.
Lock the rollers before first use.
Clean the machine of any transport contamination.
Connect the machine to the electrical supply indicated on the machine plate. If necessary, consult a
qualified electrician (RMP3545).
Perform a test run. Make sure that the two press plates are correctly in the press chamber.
The main switch on the right side of the front plate also serves as an emergency stop switch.
Turn on the device above. The compressor will start now.
The machine is equipped with a special compressor located in the rear body of the machine. You
can reach it by unscrewing the rear wall of the device (under the device Mains plug).
ATTENTION: OPEN THE MACHINE'S BACK ONLY AFTER YOU HAVE PULLED THE POWER
PLUG. DANGER!
Before starting the compressor, remove all parts from the press plates, which could damage the ma -
chine or burst and be thrown out of the machine.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
