manual-rmp210-rmp3545-en-18
Page
9 / 16
Pressure setting
As soon as you press the "PRESSURE" button, the RMP drives the press plates together. Since this
requires compressed air, the compressor will start again for about 2-3 minutes.
DANGER:
WHILE THE COMPRESSOR IS RUNNING, DO NOT OPEN THE MACHINE OR OPEN THE
DOOR TO THE PRESS ROOM.
The pressure is adjusted via the hand wheel on the front of the device.
For the correct pressure setting, please observe the processing instructions of the board material
manufacturer. As a guideline, please set a pressure of 12 tons / m² = 12 bar for a plate of
250x350mm².
Details about the pressure setting can be found in the appendix.
Timer
The timer controls the heating and cooling sequence of the
RMP 210.
The set time resembles the complete heating time including the
heating up sequence (you can calculate the approximate heat-
ing up time with the difference between set temperature minus
current temperature divided by 6 ° C / min. After the set total
time has elapsed, the heater is switched off and the cooling
phase is started when the cooling fans are switched on. To re-
set the timer, please press all 3 buttons for about 4 seconds.
Safety rules timer
Installation and connection may only be carried out by a quali-
fied electrician! Otherwise there is a risk of fire or electric
shock!
Only connect a voltage and frequency indicated on the rating
plate / timer!
Interventions or changes to the timer will void the warranty!
The timer must be installed in such a way that unusually strong interfering radiation may not affect
the function!
Key functions
[ PROG ]
Selects between hours, minutes and seconds.
[ + ]
Increments the selected time range.
[ - ]
Decrements the selected time range.
[ RESET ]
Resets to start time.
[ START/STOP ]
Starts and stops the countdown.
Setting the time
•
�
Press the [ PROG ] button once.
�
This will cause the hour digit to flash.
�
Using the [+] [-] keys to set the desired amount of hours required.
�
Repeat the process to set minutes and seconds.
�
When keeping keys [+] or [-] depressed, the flashing digit will change upwards or downwards.
�
Please note:
After starting the countdown, the key [PROG] is without function until counting is fin-
ished.
Operating the timer
Pressing the [START/STOP] button activates the relay and the set time begins to count
down in one second steps.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
