RLM419p-Manual-E
Page 4 / 13
Intended Use of Machine
The system is designed for laminating tenting resist or solder mask on printed circuit boards.
All other applications require our written consent or happen on full risk of the user.
The Bungard GmbH & Co. KG accepts no liability for damages incurred in non-authorised use or
application of the machine.
Safety Instructions
General
Please read the following instructions carefully and pay particular attention to information on operat-
ing safety and set up.
Keep these instructions at a safe place. It contains information which also refer for later mainten-
ance and cleaning.
The machines are intended for physical treatment of printed circuit boards.
The machines are not designed to be embedded or interconnected with other machines or systems.
They may only be used in specially equipped rooms and be operated only by qualified staff. Chil-
dren and pets are to be kept away!
Prepare preventive fire fighting measures, because the machine develops heat. Do not touch the
heating rollers. Danger of burn! Don't put your fingers between heating or transport rollers.
Read the information for the laminates and observe the material safety data sheets.
Do not run the unit unattended
Transport
Only use suitable lifting and transport equipment such as forklifts or pallet lifts. Secure the machine
against sliding / tilting.
Place of installation
The machine must be standing level and around the machine there has to be sufficient space for
operation and maintenance work (approx 1m on all sides).
Do not place the unit in a location near heat sources such as radiators, hot air ducts, furnace and
the like.
The laminator should be installed on a table where you have access to the front and rear side of the
unit. Special care must be taken to avoid any UV light emission to the laminate. Even white light
from normal room illumination will expose the laminate. We recommend that you install yellow safe-
light tubes or at least dim the room illumination during use and cover the laminator after it has
cooled down. A good ventilation of the room, or even a separate air exhaust close to the laminator
are recommended.
Do not run the machine in corroding, humid, dusty, extremely hot or explosive atmosphere.
If you do run the machine in an atmosphere as described above be aware that this happens
on your own risk and responsibility.
The operator has to provide appropriate safety precautions and equipment. We explicitly exclude
any warranty for damages resulting from running the machine in an atmospheres as described
above.
Electricity
The machine is made from certified parts according to standard practice for electrical safety. This
does not relieve the user of his duty of care when handling electrically powered devices.
Connect the device only to the designated power supply as indicated in this manual or on the ma-
chine plate.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 2292 / 9 28 28-0, Fax: +49 2292 / 9 28 28-29
, E-mail: [email protected]
