Available spare parts
Thermostate, Heater 400W, drain val-
ve, board holder, set of anodes with
holder and bag, air pump, conveyor
motor, conveyor arm.
Technical data
Depth
930 mm
Width
880 mm
Height
1370 mm
Working height
950 mm
Weight approx
100 kg
Power
230 V 50 Hz 2000VA
Technical details subject to change wi-
thout notice
First test
To check that your plating line was not
damaged during transport we propose
to have an initial test run:
0. Close all outlet valves.
1. Fill all treatment tanks with 10 l and
the galvanic bath with 30 liters of wa-
ter.
2. If nothing is leeking switch the unit
on by means of the red main switch.
3. Check heating function:
3.1 The heater switch button is lighted.
Press heater button and adjust tempe-
rature:
3.2 Turn the thermostate knob to preset
the following temperatures from the
left to the right of the m/c
Bath #1: Cleaner Conditioner, 65 °C
Bath #2: Pre-dip, RT (=Room temp)
Bath #3: Activator (=Catalyst), RT
Bath #4: Salt remover, 45 °C
Bath #5: Spare bath,
Bath #6: Electroplate, RT
3.3 Check if the heater switch lamp
turns off automatically at preset tem-
perature.
4. Check again after 4-5 hours if not-
hing is leeking
5. Start air agitation for plating bath
6. Start mechanical agitation and vary
agitation speed
7. If all steps of this test are passed
without problems switch off all heaters
and the main switch. Empty all tanks,
clean with fuzzel free clothes and al-
low to dry overnight.
Chemicals Set-up
We supply Plating System chemicals
pre-mixed and ready for use. All ba-
thes should be filled up to about 20
mm under upper tank level. If that le-
vel should not be reached at any time
(e.g. due to evaporation) you can top
the Activator bath with ready made ca-
talyst solution - never with water - but
all other bathes with deionised water.
Refer to the Plating System Step docu-
mentation in the appendix for details.
Bungard Elektronik GmbH&Co KG· · Rilke Str. 1 · D-51570 Windeck
Tel 02292 5036 · Fax 6175 · [email protected]
Compacta L30
Instructions for use
Plating line
Page 4
