Bulls 22-15-1054, Manual

Page: 94 / 321

MY22B01 - 22_1.0_27.08.2021
93
Operation
3 Unfasten and adjust the designated screw
connections, and clamp them with the
maximum tightening torque for the clamping
screws of the handlebars.
6.5.4.6 Adjust saddle tilt
The saddle tilt must be adjusted to the seat height,
the saddle and handlebar position, and the saddle
shape to ensure an optimum fit. The seating
position can be optimised in this way if needed.
The saddle prevents the rider from slipping
backwards or forwards when placed in a
horizontal position. This avoids seat problems. In
any other position, the tip of the saddle may press
uncomfortably into the crotch area. It is also
recommended that the centre of the saddle is
exactly straight. This ensures that the rider is
seated with their sit bones on the wide rear part of
the saddle.
1 Adjust the saddle tilt to horizontal.
2 Position saddle middle so that it is completely
straight.
Figure 98: Horizontal saddle tilt with 0° tilt in the centre of
the saddle
 The rider is sitting comfortably on the saddle
and does not slip backwards or forwards.
3 If the rider tends to slip forwards on the narrow
part of the saddle, adjust the seat position (see
Section 6.6.2.3) or tilt the saddle very slightly
backwards.
6.5.4.7 Checking saddle stability
 Check saddle stability after adjusting it; see
Section 7.5.6.
6.5.4.8 eightpins H01 seat post saddle tilt
The saddle prevents the rider from slipping
backwards or forwards when placed in a
horizontal position. This avoids seat problems. In
any other position, the tip of the saddle may press
uncomfortably into the crotch area. It is also
recommended that the centre of the saddle is
exactly straight. This ensures that the rider is
seated with their sit bones on the wide rear part of
the saddle.
1 Loosen the rear attachment screw on the seat
post head with a 5 mm Allen key.
Figure 99: Loosening the rear screw
2 Adjust saddle tilt by turning the front seat
clamping screw.
3 Tighten the rear screw with a torque wrench
and a maximum torque of 8 Nm.
Figure 100: Securing the front and rear screws
0°
Notice
Never tighten the screw on the seat post head
with more than the stipulated torque of 8 Nm as it
could break the seat post.