Bulls 22-15-1054, Manual

Page: 113 / 321

MY22B01 - 22_1.0_27.08.2021
112
Operation
6.5.11.3 ROCKSHOX Paragon Silver coil spring
Only applies to pedelecs with this equipment
1 Put on your normal cycling clothing, including
baggage. Ask someone to hold the bicycle.
Stand on the pedals while wearing cycling
clothing. Allow the damper to deflect three
times. Sit or stand on the bicycle in a normal
riding position.
2 Ask your helper to push the O-ring downwards
until it reaches the top of the dust wiper seal.
Figure 125: Moving the O-ring on the suspension fork
3 Get off the pedelec without allowing it to
deflect.
4 Note distance between dust wiper and the O-
ring. This distance is the sag.
Figure 126: Sag (1)
5 Check the sag.
Figure 127: Mandatory sag range (green) and prohibited
sag range (red)
6 If the desired sag is not achieved, the spring
preload must be adjusted internally and/or the
coil spring replaced. Contact specialist dealer.
1
Setting Sag
Prohibited >30%
High sensitivity 20–30%
Low sensitivity 10–20%
Prohibited <10
Table 41: Recommended sag
Adjusting preload internally
 Only your specialist dealer may make an
internal adjustment to the preload.
Preloading the coil spring on ROCKSHOX
Paragon forks is an internal adjustment that
compresses or decompresses the spring without
changing the deflection.
The coil spring can be preloaded 5 mm or 10 mm
using the internal preload spacer.