52
Spa pump will not turn on, creates a burning smell
while running, or makes excessive noise while running:
Cause:
Pump motor is defective.
Solution:
Contact your authorized Bullfrog Spas Dealer.
Jets are weaker than normal or do not work at all, but
the pump is running:
Cause #1:
Jet handle(s) are partially or fully closed.
Solution:
Open jet handle(s).
Cause #2:
Filter cartridge is dirty.
Solution:
See Cleaning the Filter.
Cause #3:
There is air trapped in the spa equipment or its face piping.
Solution:
Open the air bleed valve on each pump’s housing and allow air to
bleed out of the system. Be sure to tighten each air bleed valve as soon as water
starts to flow.
Cause #4:
The suction fitting(s) are blocked.
Solution:
Remove any debris that may be blocking the suction fitting(s).
Cause #5:
The JetZone Divider™ is not installed (if applicable).
Solution:
Re-install in the appropriate JetPak™.
NOTE:
Running the spa without a JetZone Divider can cause serious dam-
age to the pumps.
Cause #6:
Slice valve is closed.
Solution:
Open valve and secure with valve keeper.
Summary of Contents for I 331 Series
Page 1: ...Bullfrog Spas Owners Manual...
Page 49: ...47 Spa YardTM Stereo II Wiring Diagram...
Page 63: ......
