ASSEMBLING
THE FREE-AIR
®
PUMP
1. MODEL EDP10:
a. Open the shipping carton and remove
the top layer of foam from the box.
Remove the pump from the carton.
We recommend storing the shipping
carton and foam in the event the pump
must be shipped in the future.
b. Remove the pressure gauge from its
separate box. Assemble it to the gauge
port located on top of the pump’s outlet
filter body. The gauge should face
outward so that it can be read while
setting the pressure adjustment knob
(see Figure 1).
There is no other assembly required on
the EDP10 pump.
2. MODEL EDP16TE OR EDP16HAZ:
a. Remove the pump from the shipping
carton. We recommend storing the
shipping carton and plywood board in
the event the pump must be shipped
in the future.
Figure 1
5
b. Remove the pressure gauge from its
separate box. Assemble it to the gauge
port located on top of the pump’s outlet
filter body. The gauge should face
outward so that it can be read while
setting the pressure adjustment knob
(see Figure 1).
3. ALL PUMPS:
a. Unscrew the pump’s outlet filter jar and
check to be sure the outlet filter
cartridge is seated firmly into the outlet
filter body (see Figure 2).
DO NOT OPERATE THIS PUMP
WITHOUT AN OUTLET FILTER
CARTRIDGE (Cat. No. S17101).
Be sure the outlet filter O-ring is installed
inside the filter body.
b. Screw the filter jar back onto the filter
body. Tighten firmly by hand, making
Figure 2
sure the jar is seated against the O-ring
so that no air can escape.
c. Check to be sure that the inlet filter,
pressure gauge and outlet couplings are
all assembled tightly to the pump so that
no air can escape.
