A. OUTLET COUPLER SPLITTER
ADAPTOR
If the respirator’s air supply hose(s) have
1/2" Industrial Interchange quick-discon-
nect fittings and you want to supply air to
one of the following:
- TWO Half or Full Face Mask respirators
using pump model EDP10
or
- THREE Half or Full Face Mask respira-
tors using pump model EDP16TE or
EDP16HAZ
Connect the following Q.D. coupler splitter
adaptor to the pump (see Figure 5):
Cat. No. V24 - Double Outlet, One Flow-
Through (GREEN) & One Shut-Off (RED).
If using an 86800 or 86900 pump, connect
the splitter adaptor to either of the pump’s
two quick-disconnect couplers.
B. CONNECTING AIR SUPPLY
HOSE(S) WITHOUT 1/2"
QUICK-DISCONNECT FITTINGS
If your respirator’s MSHA/NIOSH approved
air supply hose will not attach to the pump’s
standard 1/2" Industrial Interchange outlet
coupler, (see above) you can adapt your
hose’s fitting to the pump by converting
the pump’s quick-disconnect outlet to 3/8"
Female NPT with the installation of one of
the following adaptors (see Figure 6):
Cat. No. V22 - Converts SINGLE outlet to
DOUBLE 3/8" female NPT pipe thread.
Cat. No. V23 - Converts SINGLE outlet to
SINGLE 3/8" female NPT pipe thread. A
variety of quick-disconnect fittings may be
used to connect your air supply hose to
the 3/8" female pipe thread. Contact your
respirator’s manufacturer for the proper
fitting (Hansen, Foster, Snap-Tite,
Schrader, etc.) (see Figure 7).
Figure 5
Figure 6
Figure 7
10
