Bull Novascale Blade BL465, Installation And User Manual, Page: 47 / 128

Chapter 3. Installing Options
33
3.9 Removing a solid state drive
Use this information to remove a solid state drive.
The blade server has a solid state drive expansion card for installing or removing solid
state drives. To remove a solid state drive, complete the following steps:
1. Before you begin, read the safety information that begins on page vii and Installation
guidelines on page 23.
2. Remove the SSD expansion card (see Removing an SSD expansion card on page 31
for instructions).
3. Turn over the SSD expansion card.
Figure 3-9. Removing a solid state drive
4. Press down on the blue tab. The retention lever automatically opens so that the solid
state drive or drives are accessible.
5. Slide the solid state drive out of the slot.
Note When you remove a drive from the SSD expansion card, consider labelling
the drive to indicate the slot from which the drive was removed so that you
can install the drive back into the same slot.
6. Close the retention lever and secure it with the blue tab.
Note You might have to press the blue tab before you close the retention lever.