Bull Novascale Blade BL465, Installation And User Manual, Page: 39 / 128

Chapter 3. Installing Options
25
3.2 Removing the blade server from the Blade Chassis
The following illustration shows how to remove a blade server or a blade filler from a Blade
Chassis. The appearance of your Blade Chassis might be different, see the documentation
for your Blade Chassis for additional information.
Figure 3-1. Removing the blade server from the Blade Chassis
Attention:
•
To maintain proper system cooling, do not operate the Blade Chassis without a blade
server, expansion unit, or blade filler installed in each blade bay.
• When you remove the blade server, note the bay number. Reinstalling a blade server
into a different bay from the one it was removed from could have unintended
consequences. Some configuration information and update options are established
according to bay number; if you reinstall the blade server into a different bay, you
might need to reconfigure the blade server.
To remove the blade server, complete the following steps:
1. Read the safety information that begins on page vii and Installation guidelines on
page 23.
2. If the blade server is operating, shut down the operating system.
3. Press the power button to turn off the blade server (see Turning off the blade server on
page 16 for more information).
Attention:
If one blade of the BL465 complex is operating in single partition mode, pressing the
power button on one blade server causes both blade servers to shut down.