Bull Cedoc NovaScale R423, Installation And User Manual, Page: 44 / 144

5-10
N
ovaS
c
ale R423 Installation and User's Guide
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom
notches.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
Figure 5-3. DIMM Installation
5-7 Adding PCI Add-On Cards
The NovaScale R423 can accommodate three PCI-Express x8 Gen.2 cards, one
PCI-Express x4 card (in a x8 slot), two PCI-X 133/100 MHz cards and one UIO
card. All cards must be low-profi le.
Installing an Add-on Card
Begin by removing the shield for the PCI slot you wish to populate.
Fully seat the card into the slot, pushing down with your thumbs evenly on
both sides of the card.
Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the serverboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.
1.
2.
3.
DDR2 FBD DIMM