Bull Cedoc Novascale R422, Installation And User Manual

Page: 87 / 134

BIOS POST Codes
B-1
Appendix B BIOS POST Codes
This section lists the POST (Power On Self Test) codes for the PhoenixBIOS. POST codes
are divided into two categories: recoverable and terminal.
B-1 Recoverable POST Errors
When a recoverable type of error occurs during POST, the BIOS will display an POST code
that describes the problem. BIOS may also issue one of the following beep codes:
1 long and two short beeps - video con fi guration error
1 repetitive long beep - no memory detected
B-2 Terminal POST Errors
If a terminal type of error occurs, BIOS will shut down the system. Before doing so, BIOS
will write the error to port 80h, attempt to initialize video and write the error in the top left
corner of the screen. The following is a list of codes that may be written to port 80h.
POST Code Description
01h IPMI Initialization
02h Verify Real Mode
03h Disable Non-Maskable Interrupt (NMI)
04h Get CPU type
06h Initialize system hardware
07h Disable shadow and execute code from the ROM.
08h Initialize chipset with initial POST values
09h Set IN POST fl ag
0Ah Initialize CPU registers
0Bh Enable CPU cache
0Ch Initialize caches to initial POST values
0Eh Initialize I/O component
0Fh Initialize the local bus IDE
10h Initialize Power Management
11h Load alternate registers with initial POST values
12h Restore CPU control word during warm boot
13h Reset PCI Bus Mastering devices
14h Initialize keyboard controller
16h 1-2-2-3 BIOS ROM checksum
17h Initialize cache before memory Auto size
18h 8254 timer initialization
1Ah 8237 DMA controller initialization
1Ch Reset Programmable Interrupt Controller
20h 1-3-1-1 Test DRAM refresh