Bull Cedoc Bull Escala 2104 TS4, Installation Manual

Page: 35 / 87

CAUTION:
It takes three people to lift the 2104 Model TS4. Do not attempt to lift the
2104 Model TS4 by yourself. Do not attempt to lift it without help from two
other people. (24)
CAUTION:
Do not use the handles of the fan or fan-and-power-supply assemblies to
carry the 2104 Model TS4. These handles are not intended to support the
weight of the unit. (25)
3. Move the 2104 Model TS4 into its operational position.
4. Maintain the operating temperature at 22°C (72°F) or lower.
Installing the switch cover plate
Note: Switch configuration is only valid on the SCSI interface card-1, which is on
the left side (left side from the rear view). The configuration on the SCSI
interface card-2, which is on the right side, is ignored. The switch cover plate
is on card-2 so that it can be masked. See Figure 19 on page 8. You must
place the SCSI interface card in the left side from the rear view in a single
SCSI interface card configuration. See JBOD 1 in Figure 19 on page 8.
> 18 Kg (37 lbs) > 32 Kg (70.5 lbs)
SC000325
CAUTION:
(6)
The provided cardboard lifting tool is required for moving, installing, and
relocating the product when fully populated. Three people are required to
safely move the product. Failure to do so might result in injury.
In case the lifting tool is not readily available, you must reduce the weight
to 32 Kg or less by removing all of the heavy components (disk drives
and power supplies) from the product. Then only two people are required to
move, install, and relocate the product.
Attention:
If you have data stored on the drives, label the drives before you remove them.
When you replace the drives, install each one in the same drive bay
from which you removed it. Failure to do so could result in a loss of data.
Installing and testing the 2104 Model TS4
7