Buhler Versatile 2290, Operator'S Manual, Page: 298 / 380

SECTION 3 - LUBRICATION AND MAINTENANCE
3-74
AS REQUIRED
OPERATION 73
Change the Ether Canister
The cold start solenoid is located between the oil
cooler/condenser and the radiator in the front
nosepiece on the 2360 and 2425 tractors (shown
in illustration). Access the oil cooler/condenser
by unlatching the front grille of the tractor and
swinging it out to the side.
To release the oil cooler/condenser assembly,
pull the release handle to a flat position (90
°
) and
pull the assembly toward you. It will swing the
opposite direction of the grille. The cold start
solenoid valve assembly, 1, is located on the
left-hand wall of the tractor front nosepiece (your
right as you look toward the radiator from the
front of the tractor).
The cold start solenoid is located at the left hand
rear hood support on the 2290, 2335 and 2375
tractors.
Remove the protective yellow cap, 2, or the
empty ether canister from the top of the solenoid
valve, but not the gasket. Lubricate the gasket
with a light film of clean oil.
Remove the protective cap from the new ether
canister.
2
1
Figure 3-123