SECTION 2 - OPERATION
2-141
Float (Mechanical)
To put the lift links into mechanical float position,
remove the pin, 1, securing the lower link to the
hole on the lift link. Reconnect the lower link to
the lift link using the slot on the lift link. Reverse
this procedure to convert to non-float position.
When in this position, the hitch will float
approximately 76mm (3
″
) when fully lowered.
NOTE: Full float position is achieved by
adjusting the hitch position knob on the side
console to its float detent position when in
the automatic mode.
Figure 2-196
1
Sway Blocks
Sway blocks, 1, have two positions for use with
the 3-point hitch. When the blocks are in the
sway position, the lower links can move side to
side approximately 51mm (2
″
). When in the
non-sway position, the lift arms will be limited in
their side-to-side movement when hooked to an
implement.
Figure 2-197
1
When the sway blocks, 1, are in the sway
position, the block is rotated so that the narrow
end of the block is downward.
Figure 2-198
1
Summary of Contents for Versatile 2290
