Buhler Farm King Grain Vac Conveyair 6640, Operator And Parts Manual

Page: 27 / 62

27
Maintenance - Grain Vac
8. Rotate the rotor clockwise to ensure that there is no contact between the tips, end plates and
the shell. Adjust if there is contact.
9. Mark the tip with a felt pen as done and proceed with remaining tips till all have been
adjusted.
10. Replace receiver tank and check that all connections are airtight.
........................................................................................
Blower Serial Number
Reservoir Breather
(Clean every 50 hours)
Clean breathers allow the pressure in the oil reservoir to equalize with the outside as the
temperature changes.
1. Remove breather from the top of the reservoirs.
2. Soak/Wash in a good grade of solvent.
3. Dry with an air hose and re-install.
Clamp # GV26042 Installation Instructions
Remove burrs, dirt, grease from pipe ends.
1. Measure and mark both ends of the pipe at a distance that is half the length of the coupling.
2. Slide coupling over one pipe until it meets your mark, Insert next pipe section until pipes butt.
Avoid disturbing gasket or inner sleeve.
3. Partially tighten the center bolt first , then uniformly alternate tightening all the bolts
to 65 lbs torque.
4. Tighten until top of flange is touching and there is approx. 3/16" of space at bottom of flange.
5. Make sure gasket joint and inner sleeve joint are at proper locations. (10 o’clock - 2 o’clock)
Maintenance (continued)
4"
10 O’Clock
2 O’Clock