25
Maintenance - Grain Vac
Maintenance
1.
Place PTO and hydraulic controls in neu
-
tral and shut-off engine. Disconnect the
PTO shaft from the tractor.
2.
Unlatch belt shield cover and open cover.
3.
Loosen jam nut on adjuster bolts and
loosen the bearing mounting bolts.
4.
Use the adjusting bolts to move the pulley
assembly to apply the proper tension to
the belts and also to align the pulleys with
each other.
5.
Place a straight edge across the faces of the two pulleys. Maximum allowable misalignment
is 1/16" (2 mm) on any of the pulley edges. Adjust as required.
6.
Be sure the belt tension is correct.*
7.
Tighten bearing mount bolts and jam nuts.
8.
Close and latch belt cover.
V-BELT TENSION
5005 - force = 8 to 11 pounds
5006 - force = 8 to 11 pounds
6006 - force = 11 to 15 pounds
Force per belt.
1/2 inch
deflection
Check belt tension after initial one (1)
to two (2) hours of operation and daily
thereafter.
V Belt tension testers are available at
most belt service centres.
CAUTION
Machine is shown with guard open for illustrative purposes
only. Do not operate machine with guard open.
* DO NOT MIX OLD AND NEW BELTS!
To extend the life of your bearings and
shafts we recommend that you replace all
5 belts when one or more are frayed or
broken. Older belts which have stretched
over time require a different setting than
new belts. To get the right tension on the
old belts you will put too much tension
on the new belt(s) putting undue strain on
shafts and bearings!
Summary of Contents for Farm King Grain Vac Conveyair 6640
