Chapter 4 Web Admin interface
LinkStation User Manual
143
Name
Descriptions
Maintenance
Email No-
tification
Click
[Modify
Settings]
to change
settings.
Click [Send
Test Mes-
sage] to
send a test
e-mail to
the e-mail
address
which has
been set.
Notification
Select whether using E-mail notification feature or not. Following message is
sent by using E-mail Notification.
Note: Mail Server displays the list of [POP before SMTP] (the method to give the
permission to use SMTP server by authenticating at specified POP server before
sending e-mail). If this is set, this feature cannot be used.
SMTP Server
Address
Enter [SMTP Server Address] (Mail Server Address).
SMTP Port No. Enter [SMTP Port No.].
Authentica-
tion Type
Select [Authentication Type] from [POP before SMTP], [LOGIN(SMTP-AUTH)], and
[CRAM-MD5(SMTP-AUTH/CRAM-MD5)].
POP3 Server
Address
Enter the [POP3 Server Address] (E-mail server address).
POP3 Port No. Enter [POP Port No.].
SSL/TLS
When [LOGIN(SMTP-AUTH)] and [CRAM-MD5(SMTP-AUTH/CRAM-MD5)] are
selected for [Authentication Type], specify either using [SSL] or [TLS].
Username
Enter a user name that will be used for authentication.
Password
Enter the password used to access with above user name.
Subject
Specify the subject of the e-mail to be sent. Use only one-byte characters, not
two-byte characters.
Recipient(s)
Enter the e-mail address of the receiver, and click [Add]. You can register up to 5
e-mail addresses as receivers.
Report
Select the contents to send in the e-mail notification.
• [
HDD Status Report]
Send the status other hard drive of the LinkStation on the specified time on
[HDD Status Sending Time].
• [Fan Failure]
Sent if a problem on the fan of the LinkStation.
• [Disk Error]
Sent when an error occurs on the drive.
• [Backup Complete]
When the backup job is completed
Sent if the backup of the LinkStation is completed.
