PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual
4
Disconnect the tool from power source before making any adjustments, storing, servicing, or
changing accessories. This will reduce the risk of starting the tool accidentally.
Do not force tool. Use the correct tool for your application. The correct tool will do the job better and
safer at the rate for which it was designed.
Do not use the tool if the switch does not turn it on and off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Check for damage. Check your tool regularly. If part of the tool is damaged it should be carefully
inspected to make sure that it can perform its' intended function correctly. If in doubt, the part should be
repaired. Refer all servicing to a qualified technician. Consult your dealer for advice.
Keep away from flammables. Do not attempt to operate this tool near flammable materials or
combustibles. Failure to comply may cause serious injury or death.
Store idle tools out of the reach of children and untrained persons. Tools may be dangerous in the
hands of untrained users.
Maintain tools with care. Keep tools sharp and clean. Properly maintained tools, with sharp cutting
edges, are less likely to bind and are easier to control.
Never exceed the pressure rating of any component in system.
Protect material and air lines from damage or puncture. Keep hose and power cable away from
sharp objects, moisture, chemicals, oil, etc.
Check condition of hoses before each use. Do not use a damaged hose. If hose is damaged, replace
immediately.
Read, understand and comply with all warning labels on unit.
Keep harmful arc rays shielded from the view of others.
Mount the plasma cutter on a secure bench or cart that will keep the welder secure and prevent it from
tipping over or falling.
Check all cables, power cord and torch to be sure the insulation is not damaged. Always replace or
repair damaged components before using the plasma cutter.
Check all components to ensure they are clean and in good operating condition before use.
Do not operate the plasma cutter if the torch is wet. Do not immerse the plasma torch. Do not stand in
water while using this plasma cutter. These components and the plasma cutter must be completely dry
before attempting to use it.
Keep the plasma cutter in the off position when not in use.
Connect ground lead as close to the area being cut as possible to ensure a good ground.
Do not allow any body part to come in contact with the material being cut, or to the ground or electrode
from another plasma cutter or welder.
Do not cut if you are in an awkward position. Always have a secure stance while cutting to prevent
accidents. Wear a safety harness if working above ground.
