VSFT10
ONLY
EC REP
EMERGO EUROPE
Prinsessegracht 20
2514 AP The Hague
The Netherlands
Consult Symbol Glossary at www.buffalofilter.com
Not Made with
Natural Rubber Latex
Manufactured by:
Buffalo Filter LLC
5900 Genesee Street, Lancaster, NY 14086
U.S. toll-free 800.343.2324 . International: +1 716.835.7000 . Fax: +1 716.835.3414
Email: [email protected]
www.buffalofilter.com
904194 RevC 11/09/2018
en
5. Insert the chosen tubing accessory into the
appropriate port located on the fluid trap.
6. The fluid trap is equipped with measurement
increments located on the front of the device to
approximate
the amount of fluid captured.
WARNING: Ensure that the fluid trap is not over-filled. Once the fluid level reaches 100cc, the
fluid trap should be changed.
7. Once filled, or at the end of each procedure, remove
the tubing accessory and place the appropriate cap
stored on the top of the fluid trap onto the open port.
8. Carefully remove the fluid trap from the filter and
replace the cap on the back of the fluid trap.
9. Discard the used fluid trap per facility protocol.
WARNING: The fluid trap is completely disposable and should be considered biohazardous
after use. Please dispose of according to your local codes or regulations and hospital policy.
This fluid trap may be disposed of or incinerated, whichever is appropriate for your institution.
WARNING: The fluid trap should only be used by a trained individual.
Report serious incidents involving this device to Buffalo Filter at bf.customerfeedback@
filtrationgroup.com or to your local distributor. In addition, European customers should also
report to [email protected] and the competent authority in your member state.
For single use only. Reuse, reprocessing, or re-sterilization may result in device failure
or cross contamination.
