Buell P3, Service Manual

Page: 310 / 440

2007 Buell P3: Electric Starter 5-11
HOME
STARTER 5.7
REMOVAL
1. Remove seat. See 2.28 SEAT .
1
WARNING
1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1
WARNING
1
WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Disconnect battery cables from battery, negative cable
first.
3. Remove air cleaner. See 1.17 AIR CLEANER .
4. Remove left side footpeg support bracket and primary
cover. See
2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS .
5. See Figure 5-9. Remove locknut and clamp that secure
oil hoses on right side of motorcycle.
6. Push hoses to either side to allow access to starter.
7. See Figure 5-10. Remove both starter mounting bolts
and washers.
NOTE
A ball hex driver may be required to gain access to the starter
mounting bolts.
8. See Figure 5-11. Remove positive battery cable from
solenoid.
a. Remove protective boot if present.
b. Remove nut with washer (metric) that attaches posi-
tive battery cable to post.
c. Remove positive battery cable ring terminal.
d. Detach solenoid connector [128].
9. Remove starter and gasket.
Figure 5-9. Oil Hose Clamp
Figure 5-10. Starter Mounting Bolts and Washers
(Primary Side)
Figure 5-11. Starter Wires
7767
1. Locknut
2. Clamp
1
2
7766
7768
1. Positive battery ring terminal
2. Connector [128]
2
1