Buell P3, Service Manual

Page: 206 / 440

2007 Buell P3: Engine 3-23
HOME
32. See Figure 3-41. Install front isolator mounting bolt,
spacer snubber and new nut.
33. Tighten front isolator mounting bolt to 63-70 ft-lbs (86-95
Nm).
34. See Figure 3-42. Install crankcase breather hose and
crankcase breather into rocker box grommet.
35. Install horn. See 7.22 HORN .
36. Remove jack from under the motor.
37. Install muffler. See 2.20 EXHAUST SYSTEM .
38. Install fuel tank. See 4.2 FUEL TANK COVER/FUEL
TANK .
39. Install new oil filter, engine oil and primary chaincase
fluid as necessary.
40. See Figure 3-43. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS .
1 1
WARNING
1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
41. Connect both battery cables, positive cable first. See
7.16 BATTERY .
1 1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
42. Install seat. See 2.28 SEAT .
Figure 3-41. Front Isolator Mount
Figure 3-42. Install Crankcase Breather Hose
1. Frame
2. Locknut
3. Snubber
4. Bolt
5. Spacer
6. Front isolator
7. Standoff
1
a0162x6x
2
4
5
6
7
3
7629
Figure 3-43. Footpeg Bracket Assembly
1. Frame
2. Locknut
3. Washer
4. Spacer
5. Footrest support bracket
6. Clevis pin
7. Footpeg
8. Cotter pin
9. Index plate
10. Spacer
a0016x3x
1
2
3
4
5
6
7
10
9
8