Buell 2002 X1, Service Manual

Page: 432 / 462

7-34 2002 Buell X1: Electrical
HOME
TURN SIGNALS 7.13
REMOVAL
Bulbs
Remove screw on back of housing to access turn signal
bulbs.
Front
1. Remove windscreen and headlamp. See 7.11 HEAD-
LAMP .
2. See Figure 7-42. Disconnect bullet connectors on turn
signal wires.
3. See Figure 7-43. Remove nut (1) and lockwasher (2)
from mounting bracket (3).
4. Remove turn signals (4) and standoffs (5).
5. Pull bullet connectors (6) and wiring through hole in
mounting bracket (3).
Rear
1. Remove trunk. See 2.37 TRUNK .
2. Cut cable straps to access bullet connectors under tail
section.
3. See Figure 7-44. Disconnect bullet connectors on turn
signal wires.
4. See Figure 7-45. Remove nut (1) and lockwasher (2).
5. Remove turn signal (3) from outside of trunk.
INSTALLATION
Front
1. See Figure 7-43. Insert bullet connectors (6) through
hole in mounting bracket (3).
2. Install turn signal (4) and standoffs (5) using lockwasher
(2) and nut (1). Tighten nut to 25-28
in-lbs
(2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-42.
4. Install and align headlamp. See 7.11 HEADLAMP .
1
WARNING
1
WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
Figure 7-42. Front Turn Signal Connections
Figure 7-43. Front Turn Signals
S5
BK BE
V LT.BE
S9
S4
W
BK
Y
2
3
4
O/W 1
BK
W
O/W
Y
POSITION LMP
HIGH BEAM
LOW BEAM
LMP GROUND
BN R/BK
K B BE
b0620x7x
Right Turn
Signal
Left Turn
Signal
Headlamp
Headlamp
Connector
b0619a7x
1. Nut (2)
2. Lockwasher (2)
3. Mounting Bracket (2)
4. Turn Signal (2)
5. Turn Signal Standoff (2)
6. Bullet Connectors (2 per signal)
4
5
3
2
6
1