6
Fitting the mounting bracket
SKR6.1R, SKR12.1R - Subject to technical modifications.
15
6.2
Installing mounting brackets on roof
tile roofs
B
Depending on the distances (
Æ
page 14), remove 2-3
roof tiles from a row in the area of the rafters.
B
Position the mounting bracket:
– The mounting bracket must be in the tile valley.
– The mounting bracket must be installed directly
above the roof tile below it without touching this tile.
B
Mark the mounting bracket positions on the roof.
B
Place mounting bracket [1] on rafter and pre-drill using
a 6 mm drill bit. Fasten with the screws [3].
B
If required, use wooden spacer [5] for height
compensation (pre-drill 9 mm).
B
Carefully remove the roof tiles' drip edges and profiles
[2] and [4] in the area of the mounting brackets.
B
Screw mounting bracket with 3 screws 8 x 120 mm [3]
onto the rafter. Use a SW13 spanner for tightening.
B
Put the roof tiles back on.
Fig. 21 Mounting brackets for roof tile roofs
1
Mounting bracket
2
Top roof tile
3
Screws 8 x 120 mm
4
Bottom roof tile
5
Wooden spacer 100 x 150 x 8 mm
NOTICE:
Roof leaks from fine, wind-driven
snow in the area of the mounting bracket.
B
If there is a larger gap between the top
and the bottom roof tiles, close this gap
using UV-resistant sealant.
6720646203-07.1ST
1.
3.
2.
2
4
3
1
5
13
6
9
