4
Placing the boiler
Logano GB125 BE US/CA - Technical specifications are subject to change without prior notice.
17
4.2
Reversing the burner door
The burner door is factory-fitted with the hinges on the
right – the burner door opens to the right. You can change
the burner door hinges over to the left-hand side if
required to suit the installation site.
Requirement: the burner hood must have been removed
first (
Æ
Chapter 3.1, page 14).
V
Removing the burner door (
Æ
Chapter 3.1, page 14).
V
Unscrew the hinge-pin bolts [1] and remove the hinge
pins [2].
V
Fix the hinge pins [2] on the left-hand side of the boiler
using the hinge-pin bolts.
Fig. 9
Reversing the burner door (boiler heat
exchanger attachments)
1
Hinge bolts
2
Hinges
V
Unscrew the hinge-barrel bolts [1] and remove the
hinge barrels [2].
V
Fix the hinge barrels [2] on the left-hand side of the
burner door [3] using the hinge-barrel bolts.
V
Hang the burner door [3] by locating the hinge barrels
[2] on the hinge pins [4].
V
Check that the heat exchanger baffles are placed hori-
zontally (
Æ
Chapter 6.3, page 34).
V
Close the burner door [3] and secure with the two hex-
agon-head bolts. Tighten the hexagon-head bolts
evenly (approx. 90 lb ins) so that the burner door seals
properly.
Fig. 10 Reversing the burner door (door attachments)
1
Hinge-barrel bolts
2
Hinge lobes
3
Burner door
4
Hinges
5
Heat exchanger baffle plates
7 747 019 141-08.1RS
1 2
2 1
If the burner door hinges have been changed
over to the left-hand side, the burner cable
must be disconnected from the burner before
opening the burner door.
7 747 019 141-09.1RS
1
4
5
2
3
