now!Board™ User Manual 16
5.
Calibrate now!Board
™
by following the
on-screen instructions on the display
surface. Use the stylus or the wand to
touch the exact middle of each of the
nine calibration points, one at a time,
as they appear.
Be sure to hold the stylus correctly as
shown (Figure 27).
Hold the stylus flat against the display
surface as shown (Figure 28).
Press the tip firmly against the display
surface to select each calibration point.
Do not press the side button on the
stylus during calibration. See
Using the
Stylus
for more information.
6.
The calibration points give information
regarding the laser light position. If the
(Figure 27)
(Figure 28)
4.
You will see this screen (Figure 24).
Turn, tilt or raise the camera until the red laser light
is pointing near the center of the red circle on the
display surface (Figures 25 & 26).
Note:
When calibrating now!Board
™
with a TV
monitor, in some cases the laser light might not be
visible on the display surface. Place a white piece of
paper in front of the monitor to help view the laser
light.
Tilt the camera to move the laser light up or down
(Figure 25).
Raise the camera by gently pulling on the top to clear
obstructions (Figure 26).
(Figure 24)
(Figures 25 & 26)