WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada CSA Z94.3) when
using as a blower. To reduce the risk
to bystanders, keep them clear of
blowing debris.
CAUTION:
• Wear a dust mask if blowing
creates dust which might be
inhaled.
• To reduce the risk of hearing
damage, wear ear protectors when
using the vac/blower for extended
time or in a noisy area.
Blowing Feature
Your vac has the capability to blow
sawdust and other debris.
Insert one end of the hose into the
blowing port and begin operating.
!
WARNING: To reduce the risk of
injury, unplug powerhead before
servicing the electrical parts of the
Wet/Dry Vac powerhead.
!
!
Your filter should be frequently replaced
to maintain peak vac performance.
Do not tear the filter during removal or
installation if your intent is to reuse the
filter.
Replacing the Filter
1. Extend the retainer band around the
plastic posts on the lid.
2. Remove filter bag from the filter cage.
3. Clean the area of the lid so that the
retainer band will seal the bag against
the lid and stop small particles from
bypassing the filter bag.
4. Place the replacement filter on the filter
cage until open end touches bottom of
lid.
5. Release the retainer band from the
plastic posts on the lid, holding the filter
bag secure to the lid.
6. Make sure the retainer band is
positioned on the filter bag covering the
black printed line.
Filter
IMPORTANT:
To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the vac for dry
material pick-up.
Power Head
(upside-down)
Retainer Band
Filter
Lid
Plastic
Post
Filter
WARNING: Do not remove the
filter cage and float. The float
prevents liquid from entering the
impeller and damaging the motor.
The cage prevents fingers from
touching the moving impeller.
MAINTENANCE
!
SP6726 BUCKET HEAD 0809 8/26/09 5:04 PM Page 7
