Buchi R-210, Operation Manual

Page: 36 / 80

5 Putting into operation
36
R-210/215 Operation Manual, Version B
5.6 Installing the refl ux insert
1
2
3
4
5
Fig. 5.6: Installing the refl ux insert
To install the refl ux insert, proceed as follows:
Take the standard fl ange screwed connection
off the drive unit.
Fix the gasket WD 26 (seal) (position 3) to the
refl ux insert (position 2).
Mount the refl ux insert onto the drive unit.
Mount the fl ange srewed connection
(position 1) without tightening it.
Check whether the O-ring (position 5) is posi-
tioned properly within the refl ux insert.
Mount the condenser of the glass assembly
(position 4) to the drive unit and fi x it by
tightening the fl ange screwed connection.
•
•
•
•
•
•
5.7 Mounting the support rod (optional accessory)
1
2
3
4
The support rod with bracket and plastic clip is
used with the glass assemblies V, C, S, BY and
CR. It is optional and has the sole purpose of
providing additional stability. We especially
recommend it for the glass assemblies C and
CR.
To attach the support rod to the drive unit, pro-
ceed as follows:
Insert the support rod into the hole on
the drive unit.
Secure the support rod by means of the
screw .
Fasten the clip at the desired height by
means of the wing nut.
•
•
•
Fig. 5.7: Mounting the support rod
ATTENTION
The support rod is not designed to carry the weight of the glass assembly on its own. Its sole
purpose is to stop the glass assembly tilting forward or backwards when the fl anged coupling is
released.