www.btxinc.com
Dallas, Texas - USA
How to Enter “Single Select” Program Mode
Programming Groups
1. Select the desired group channel on handsender.
2. Press the “Program” button on each of the motors you want to group together. All
systems should start stepping.
3. Press the “Program” button on the back of the handsender. All systems should stop
stepping for a moment to confirm the channel is learned, then continue stepping.
4. Press the “Program” button on each motor to exit program mode.
Multiple motors of different types can be programmed together in a group (or multiple
groups). For best per formance, BTX recommends grouping systems by operating direction
(lifting systems together and traversing systems together). This is due to the fact that
operation of these systems varies from “Up” and “Down” to “Left” and “Right”.
Setting a Group
1. To enter
Single Select
mode, hold the “Stop” button on the front of the handsender
while pressing the “Program” button on the back of the handsender. You will need a
pen or paper clip.
2. The handsender will now enter search mode and look for any motors within the
listening range and place the first-recognized motor into program mode. While in
search mode, the LEDs on the handsender will cascade up and down. If the located
motor is not the one you desire, press the “Right” or “Left” button on the remote to
cycle to another motor.
3. Once your desired motor is located, per form any programming functions you require.
4. You can exit
Single Select
mode at any time by quickly pressing the “Right” button
twice.
Single Select
mode can be used to identify and program motors without using the
program button located on the motor head. This mode will cycle through motors that are
currently learned to your handsender, or are still in factory default mode.
Single Select
WILL NOT
place motors learned to other handsenders in program mode.
