www.btxinc.com
Dallas, Texas - USA
2.4 GHz Tubular Motor Programming
(Roller Shade & Gemini)
Setting Limits
Reverse Motor Direction
Toggle Momentary/Maintain Option
To Erase Handsender from Motor
1. If not already in program mode, press the “Program” button on the motor and the
system will begin to step back and forth.
2. Select the appropriate channel on the handsender.
3. To set the upper limit, hold the “Up” button on the handsender until you’ve reached
the desired location. Once reached, press and hold the “Stop” and “Down”
buttons simultaneously for approximately 3 seconds. The system will stop stepping
for a moment to confirm the limit is set, then will continue stepping. Continue
programming or exit program mode by pressing the “Program” button on the motor.
4. To set the lower limit, hold the “Down” button on the handsender until you’ve
reached the desired location. Once reached, press and hold the “Stop” and “Up”
buttons simultaneously for approximately 3 seconds. The system will stop stepping
for a moment to confirm the limit is set, then will continue stepping. Continue
programming or exit program mode by pressing the “Program” button on the motor.
1. If not already in program mode, press the “Program” button on the motor and the
system will begin to step back and forth.
2. Select the appropriate channel on the handsender.
3. Press and hold the “Up” and “Down” buttons on the remote simultaneously for
approximately 3 seconds. The system will stop stepping for a moment to confirm the
change is set, then will continue stepping. Continue programming or exit program
mode by pressing the “Program” button on the motor.
1. If not already in program mode, press the “Program” button on the motor and the
system will begin to step back and forth.
2. Press and hold the “Program” button on the motor for approximately 3-5 seconds. The
system will give a quick jog then continue stepping. Continue programming or exit
program mode by pressing the “Program” button on the motor.
1. If not already in program mode, press the “Program” button on the motor and the
system will begin to step back and forth.
2. Select the appropriate channel on the handsender.
3. Press the “Program” button on the back of the handsender. The system will stop
stepping for a moment to confirm the handsender is erased, then will continue
stepping. Continue programming or exit program mode by pressing the “Program”
button on the motor.
