6
EN
Installation
Operating instructions
1. Close the door, place the mounting plate (5) and the bolt housing (4) between the door
frame and the door. Paint the holes to drill and fix the base with the screws provided.
2. Fix the bolt body to the anchor base and tighten the 4 screws firmly so that it is securely
fastened.
Make sure that the bolts of the lock match correctly in the bolt housing part.
3. After installation, check with the remote control that it works properly.
MAIN DRIVE BUTTONS:
Close the door: Press on the remote control. A beep will sound.
Open the door: Press
on the remote control. Three beeps will sound.
REINFORCEMENT DRIVE BUTTONS:
The reinforcement circuit is normally in the off position. It can be activated in the event of
the main batteries being depleted. To activate it you will need to tap the door several times
in the place where the lock is installed. A beep will sound, then tighten the reinforcement
drive buttons (
& ); If you do not press them after a few seconds, you will return to
the main drive.
1
2
3
4
5
6
7
1. Manual spinning knob
2. Battery cover
3. Battery cover screw
4. Bolt housing
5. Mounting plate
6. Receiving antenna
7. Remote control
Pairing remote controls
All remote controls are factory paired.
CANCEL ALL THE REMOTE CONTROLS:
This option will make all remote controls unusable.
Main buttons: Press and hold the ST-2 button. You will hear a beep. Keep pressing for
about 8 seconds, until two more beeps sound. All the main buttons on the controls will be
canceled.
Reinforcement buttons: Press and hold the ST-1 button. You will hear a beep. Continue to
hold for about 15 seconds until two more beeps sound. All the reinforcement drive buttons
of the controls will be canceled.
