391696
26
• Terminal Resistor Setup
• The terminal resistor is used if your system is one of following two cases.
•
Case 1: Control cable between camera and controller is relatively very long (1:1 connection)
If communication cable is very long, the electrical signal will bound in the terminal point. This reflected signal
cause distortion of original signal. Accordingly, the camera can be out of control. In this case, the terminal
resistor of both sides i.e. camera and controller must be set to ‘ON’ state.
•
Case 2: Multiple cameras are controlled at the same time
Due to similar reasons with case 1, the terminal resisters of controller and the last camera must be set to ‘ON’
state. Last camera means decided by cable length. Do not turn on the terminal resistor of all cameras.
The complete informations are in the manual on the CDrom
Summary of Contents for LE03110AA
Page 21: ...21 PACKAGE COMPONENT Product Accessories Optional...
Page 36: ......