30
Regular situation:
Check the good GSM signal level in order to call and receive the
voice call (GSM led ON or Blinking).
PIN required:
digit the PIN code, described in the following paragraphs.
Roaming / Virtual operator:
enable the Roaming calls, described in the following paragraphs.
2.2
OUTGOING CALL
Hook off the phone, wait for the dial tone, then digit the phone number.
After the last digit GSM/PSTN interface waits for 5 seconds before dialing the phone number; the
“#” hash button informs GSM/PSTN interface that the phone number is complete, and it can go on
with the call.
2.3
INSERT THE PIN CODE
If the protection PIN code of the SIM card is enabled and the PIN has not been set in the gateway,
the Status led is ON and the PIN code request is transmitted to the phone line (double beep
repeated with a short pause).
Insert the PIN code using the phone keypad (set DTMF selection) connected to the TEL1 or TEL2
ports:
1. Hook off the phone, you hear the PIN code request tone.
2. Enter the PIN Code using the phone keypad (using a DTMF phone) and confirm by pressing the
“#” (hash) button.
PIN code#
(i.e. 0123#)
3. To cancel the wrong PIN code, hang up before sending the “#” (hash) button.
4. If the PIN code is correct you will hear the configuration tone (continuous tone repeated twice).
5. Hook on the phone and wait for detection of the GSM network.
6. If the PIN code is wrong you will hear the wrong configuration tone (single long tone).
ATTENTION: PIN and PUK codes are present on PIN-PUK card provided by GSM
Operator when you buy the SIM card. Please note that you have 3 possibilities to
enter the right PIN code. If insertion fails, you must insert the PUK code and a new
PIN code.
If you write a wrong PUK code 10 times, the SIM card will be blocked.
The PIN code is automatically stored into GSM/PSTN interface and it will be used when necessary.
If the SIM card is removed or stolen then you must newly insert the PIN code manually.
To delete the PIN code from device memory, enter #*99# code using the phone keypad connected
to TEL1 or TEL2 connector.
Check the good level of GSM signal and eventually try to improve it by placing the antenna in a
different position.
