Type of system
A
PL
M
G
Traditional system
None
None
None, 1÷8, PUL, O/I
None
My Home system
1÷9
1÷9
None, 1÷8, PUL, O/I
None, 1÷9
Configurator in M
Duration of activation
1
1 minute
2
2 minutes
3
3 minutes
4
4 minutes
5
5 minutes
6
15 minutes
7
30 seconds
8
0.5 seconds
CONFIGURATION
10
The basic radio actuator can be used in both a traditional system and a
My Home system.
In both cases it must be first configured and then programmed.
The basic radio actuator can be controlled by radio control devices such as remote control item 3527, transmitting radio interface
L/N/NT4576N, HC/HS4576 and radio control item H/L4572.
For the external contact which may be connected to the actuator a mode of operation can be chosen from those listed in the table
below. The mode of operation for the external contact is determined by the type of configurator in socket M.
When used in a traditional system
, the sockets of configurators A, PL and G are not used.
When used in a My Home system
, transmitting radio interface item L/N/NT4576N must be installed and the actuator must be
configured putting the correct configurators in the sockets of configurators A, PL, M and G. The actuator performs all the basic
modes of operation which can be configured directly on the radio control devices, apart from those which require the use of two
interlocked relays.
For details of the configuration refer to the following tables.
Description
Combination configurator in M
and type of external contact
Pushbutton
Switch
ON/OFF cyclical
No configurator
—
Monostable mode. (If installed
in a My Home system the
actuator ignores the Area and
General commands)
PUL
—
ON/OFF mode. Variations
on the fronts (toggle)
—
O/I
Timed ON *
1÷8
—
The table lists the modes of operation with the configurator
in position M:
* If controlled by external pushbutton the
device switches off after a time established by
the configurator in M, as indicated in the table.
The configuration operations must be performed with the actuator switched OFF.
11
PROGRAMMING
1. Switch on the device.
2. Keep the local key pressed until the LED lights up (about 4 seconds).
3. Release the key.
4. Within 20 seconds send the signal from the radio control device to be programmed.
Example:
For remote control item 3527 press the key to be associated with the actuator.
5. The LED flashes and then goes out, indicating that programming has taken place.
6. Repeat the sequence of operations from point 2 to point 5 for all the radio control devices to be programmed (max 16).
12
CANCELLING
This operation cancels all the radio control devices previously programmed in the actuator.
1. Switch on the device.
2. Keep the local key pressed; after 4 seconds the LED lights up, keep the key pressed until the LED goes out.
3. Release the key.
4. The LED flashes and then goes out, indicating that all the radio control devices previously programmed in the actuator have been
cancelled.
