BTEK T401S, User Instructions

Page: 48 / 62

48 T401S Indicator User Instructions
Supervisor menu
8.3 Counting application supervisor menu
Figure 8.3 shows the Supervisor menu when you are in the Counting application:
Figure 8.3 Supervisor menu for the Count application
Follow these steps to set the items in the Supervisor menu.
8.3.1 Count
Super  Setpoint  Count
1. With the Count application active, access the Supervisor menu using password
1793. Refer to
Accessing the menus on page 25 for instructions. From SuPEr ,
press SELECT …
SEtPnt is displayed.
Count
Super
Setpnt
Edit Print Reset
No Yes
Battery
Enable Tmout
Off On
Port 1 Port 2
Out1 Out2 Out3 In1 In2 In3
None Print Units
Select Tare Zero F1 Accu PrntHld User
Off On
Annun
Prt Tot Tot Fmt Clr Tot Reset
Off On No Yes Off On
Bold boxes and text
denote defaults.
1-3600
minutes
Key
in
value
Key
in
value
Key
in
value
Enter Print
format #
for Total
operation
SELECT =
TARE =
PRINT =
UNITS =
ZERO =
F1 = Escape or
The Setpnt and bAttErY submenus in Figure 8.3 are the same as described in
General Weighing application supervisor menu on page 40 . Go there for information
on those submenus. The unique submenus to this application are described below.
The cnt Acc submenu is the same described in the Accum submenu in the
Accumulator application. Refer to step 3 on page 46 .