BTECH UV-25X2, User Manual

Page: 33 / 83

26 VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
UV-25X2 / UV-25X4 / UV-50X2
transmitter will not transmit if a channel is receiving at the time
16. [Enter Menu]+ [1] + [6] : SC-ADD - scan settings. OFF: This removes the channel from the
scan list. ON: This adds the channel to scanning list.
17. [Enter Menu]+ [1] + [7] : SC-REV – Scanning settings. TO: time out scan, after the stopping
on an active signal, scanning will resume after a few seconds. CO: Scanning will stop on a
carrier channel and will resume after the carrier channel stops receiving SE: Scanning will
stop once an active carrier channel is found.
18. [Enter Menu]+ [1] + [8] : OPTSIG – Turn on the optional signaling. OFF the channel or mode
will not use optional signaling DTMF: DTMF signaling required. 2TONE: 2 tone signaling
required. 5TONE: 5 tone signaling required. (PC programming is required to specify the
DTMF, 2Tone, and 5Tone settings)
19. [Enter Menu]+ [1] + [9] : SPMUTE – Squelch settings when combining standard and
optional tones. QT: The squelch will open for just a CTCSS or DCS Receive tone. AND: This
requires both the optional tone settings (Menu 20) and CTCSS/DCS settings to be received.
OR: If a either the DCS/CTCSS or optional signaling is received the squelch will open
20. [Enter Menu]+ [2] + [0] : PTT-ID - PTT-ID transmit setting. OFF: no ID code sent when
transmitting. BOT: send ID code at Beginning of Transmit. EOT: send ID code at End of
Transmit. BOTH: send ID code at both beginning and end of transmit. (PTTID code
information can only be set by the PC software)
21. [Enter Menu]+ [2] + [1 ] : PTT-LT - PTT-ID transmit delay setting. (Delay Time range is 0-30
seconds.). This is the delay time before transmitting the PTTID