15
CONFIGURING HANDSETS AND LINES.
CONFIGURING HANDSETS AND
LINES.
Each W52P base station can have up to 5 handsets registered to it and provision up
to 5 lines, but it will only support 4 calls at the same time. The default set-up is based
on each line being used by a specific handset for all calls made and received i.e. line 1
is used by handset 1, line 2 is used by handset 2, and so on.
You can change the default set-up and specify which handsets use which lines for
incoming and outgoing calls through the W52P web user interface.
To allocate handsets and lines:
1. Find the IP address of a W52P base station by pressing the paging key (see
page 7). The IP address is shown on the LCD screen of any handsets that are
registered to it. Make a note of the IP address as you’ll need it later.
2. Browse to the W52P IP address from an internet browser on the same network as
the base station.
3. The web user interface will ask for a username and password. Enter user as the
username and password as the password.
4. Click on the
Account
tab and then on
Number Assignment
in the left hand menu.
5. You’ll see two tables with tick boxes. The top table lets you set which handsets
can receive calls for each line provisioned. The lower table lets you set which lines
each handset can use to make calls and the default line to use.
This shows a default set-up where 5 handsets each have their own user accounts and
phone numbers for incoming and outgoing calls.
6. Click
Confirm
to save any changes that you’ve made.