3.4 Setting and using the Alarm (only when Mains Powered)
■
Switch on the DMP.
■
The time must be set before an alarm can be set, see 3.2 Setting the Time
■
Press and hold the Mode Select button until SETUP MENU is shown on the display.
■
Scroll through the Setup menu by pressing the Mode Select button until the display shows ALARM MODE
BUZZER (or ALARM MODE FM RADIO)
■
Press the Tune down or Tune up buttons to select either Buzzer or FM Radio.
■
Press the Mode Select button 3 times until the display shows SAVE SETTINGS & EXIT
■
Press the Tune up or down buttons to save the changes.
PLEASE NOTE:
If you have selected the FM radio as your alarm mode the alarm will always wake you up to the FM radio station
stored as preset 1.
■
Switch off the DMP by pressing and holding the Power button until the display shows GOOD BYE.
■
Press and hold the Mode Select button until the display shows ALARM NOT SET. If you have not set the time
the display will show CLOCK NOT SET, see 3.2 Setting the Time.
■
Press and hold the Mode Select button again until the display shows SET ALARM 00:00
■
Use the Tune down button to select the hour and the Tune up button to select the minutes.
■
When you have set the time for your alarm call press the Mute button.
■
A small bell will appear on the display to show the alarm has been set.
■
Pressing the Mode Select button once will show ALARM SET in the display with the time you have selected.
■
Press the Mode Select button again the display will show the current time with a small bell.
3.4.1 Switching the Alarm off
■
When the alarm goes off press the Mute button to switch off
3.4.2 Switching the Alarm to Snooze
■
When the alarm goes off press the Mode Select button to switch to snooze, the display will show scrolling Zz.
■
The alarm will go off every 9 minutes while in snooze mode.
■
Press the Mute button to switch the snooze off.
3.5 Changing the Radio Link Channel on the DMP
It is recommended that you leave the default Channel number in your DMP unless you have more than one
DMP and PC combination working within close proximity.
The five channels allow you to use multiple PC/DMP combinations by selecting different channels for
each set-up.
■
Switch on the DMP.
■
Press and hold the Mode Select button until SETUP MENU is displayed.
■
Press the Mode Select button and RADIO LINK CHANNEL n is shown on the display (where n is the current
setting 1 – 5, the default is 3).
■
Use the Tune down button to move down the channel numbers and the Tune up button to move up the
channel numbers.
