39
No ring on cradle
The ringer volume may be turned down too
low. Press the volume switch on the cradle
to increase the ringer volume.
Check that the Easicom 200 is plugged into
the phone socket.
Check that the cradle is plugged into the
mains power and switched on.
Organiser does not function at all
Try resetting the organiser. See page 35.
Switchboard/PBX code does not get an
outside line
There may have been a power failure and
your switchboard/PBX setting has been
lost. To check your setting see page 36.
You may need to enter a pause after the
access code to allow enough time for the
switchboard/PBX to get an outside line.
Flashing IN USE/CALLS light
There is an incoming call
Flashing POWER light
The cradle back-up batteries are low.
Replace batteries as soon as possible to
ensure your Easicom 200 will continue
working if the mains power fails.
Your Easicom doesn’t disconnect from
a call when the handset of an attached
telephone is replaced.
Check that your telephone is plugged into
the Easicom cradle rather than the
telephone wall socket.
Organiser seems to be getting slower
The memory may be reaching its capacity.
Try optimising the memory, see page 34.
If you are still experiencing difficulty, call
the Easicom 200 Helpline on
0345 573464
.
Lines open 8.30am-5.30pm, Monday-
Friday and 12pm-5pm Saturday, excluding
bank holidays.
