Converse 2025 2-Line ~ 4th Edition ~ 10th September ’02 ~ 4515
8
SETTING
UP
1
Install the batteries
The memory and the display on your Converse
2025 is powered by 4 x AA alkaline batteries.
Make sure the desk/wall mounting plinth is not
attached to the base of the phone.
Make sure the phone is not plugged into the
phone socket.
Use a screwdriver to remove the screw on the
battery compartment cover.
Use the tip of the screwdriver to push the
battery compartment cover’s catch then lever
up to open the cover.
Insert batteries as shown.
Close the cover and replace the screw.
Plan the location
Situate your Converse 2025 close enough to the
phone sockets so that the line cord will reach.
Your Converse 2025 can be wall-mounted. See
‘Wall-mounting’
, on page 24.
Setting up
Note
When your batteries are close to becoming
completely flat,
will flash in the upper
left corner of the display. If you do not replace
batteries they will become totally discharged.
Whilst batteries are in good condition the
Directory and One-touch memories will be
retained. Battery replacement should be
completed within 2 minutes or the memory
contents may be lost.
If no batteries are installed, the
will
only appear when the phone is off the hook as
this activates the display.