7
Installing / dismantling the spectral measuring head
32/38
iPQ-Spectral – Spectral measuring head (C11 SensorUnit)
7
Installing / dismantling the spectral measuring head
Overview
To send in the spectral measuring head for maintenance pur-
poses, it must be removed from the traverse bar.
CAUTION
Danger of crushing caused by motorized traverse bar!
There is a danger of crushing when body parts enter the space
between the camera unit/spectral measuring head and traverse
bar!
►
Prior to starting assembly, maintenance and cleaning work, isol-
ate the system and secure it against being switched on again.
►
Ensure that no body parts are within the hazard zone of the tra-
verse bar.
CAUTION
This work may only be performed by qualified personnel! (see
chapter
Qualification of the Personnel, page 13
)
Required aids
Allen key (4 mm)
Preparatory work
►
Switch off the entire iPQ-Center system.
7.1
Removing the spectral measuring head from the traverse bar
If you are using the spectral measuring head with out the optional
cameraunit, please continue reading in chapter
spectral measuring head, page 33
. If you are using the optional
camera unit,you have to remove the camera unit before you re-
move the spectralmeasuring head. Continue reading in chapter
Dismantling the camera unit, page 32
in this case.
7.1.1
Dismantling the camera unit
Perform the following steps to remove the camera unit from the
traverse bar:
