BST Solutions GmbH | FLAME DETECTOR KLC 20 / KLC 21
Page 9
2.3 Safety instructions
Before working at the flame detector switch off the power supply. Before first commissioning
or replacement of the device check external wiring!
The following instructions on accident prevention have to be observed when operating the
flame detector:
2.4 Safety devices
2.4.1 Fundamental aspects
Check the safety equipment and locking devices on the device for safe operational condition.
Only operate the device if all safety devices are present and enabled. The operating company
or operator of the flame detektor is responsible for the proper operation of the device.
SAFETY
Only operate the device if it is in a proper state.
• Do not remove or disable safety devices.
• Check for externally noticeable damage and defects prior to using the device. Imme-
diately notify the appropriate authority/person of any changes that occur (including
changes in operating performance). If necessary, stop and secure the device imme-
diately.
• Allow only authorised specialist staff to carry out set-up and/or maintenance work.
• Replace worn or defective parts.
• Use suitable maintenance tools only.
• After repair work, refit all safety devices and carry out electrical and mechanical
checks.
• Check the operating manual for details of displays as well as switch-on and switch-
off procedures.
• Prior to switching on the device, make sure that no-one can be endangered by the
device.
• The operating manual always have to be kept close to the device and be readily at
hand.
• Any non-compliance with the safety instructions outlined in this operating manual
may lead to damage to property, personal injury or even death.
The device has been fitted with warning and danger signs for the protection of ope-
rating staff. These signs have to be observed. Damaged or illegible signs have to be
replaced immediately.
NOTICE
NOTICE
