- 7 -
Diagram 7
Diagram 8
Diagram 9
Diagram 10
Diagram 11
E. Water Pump Installation
Step 1: Make sure the water pump is not cracked or damaged in any way.
Step 2: Attach the end of the tube to the pump nipple and L -shaped water flow at the
back of blade guard.
Step 3: Place the Pump at the location in the water tray that has been designed to secure the
pump during use. (See the Diagram 7).
Step 4: Pour the water into the water tray and make sure the water level is higher than
the pump intake nozzle.
Step 5: Keep the power cable end out of water and plug the power cable into the socket
on the side of the cutting head assembly. The pump is activated by the ON/OFF switch
of the tile saw.
Step 6: Make sure that the water valve connecting the pump to the tubing is in the full
open position.
The following is the water pump safety guidelines.
1. Make sure the pump is connected to grounding-type socket to prevent the electric shock.
2. Make sure the pump and tube is settled steadily to reduce any chance of pump damage.
3. Do not handle the pump by the power cable, with wet hands, or when standing on a
wet surface.
4. Never use the pump for anything other than water, especially petrol, kerosene,
or other combustible or corrosive liquids.
5. Do not attempt to check the pump before disconnecting the power source if the pump fails
to operate.
6. Never operate the pump without water. The pump needs water to cool its own motor.
A dry pump may cause damage or danger.
F. Installing Rear Water Collection Tray
1. Insert and attach the Back Collecting Tray to the Tank at the corresponding joints.
(See Diagram 8)
G. Installing Extension Table & Side Extension Table
1. Installing Front Extension Table (See Diagram 9):
a. Place the Extension Table in the back of the Main Working Table.
b. Secure the Extension Table with the supplied round cap HEX bolts.
2. Installing Side Extension Table (See Diagram 9):
a. Insert the Side Extension Table tubes into the side tunnels at front and back of
the Main Working Table.
b. Insert the Pins at the ends of Side Extension Table tubes to hold them in place.
Make sure that the directional arrow on the blade
points in the same direction as the arrow marked on
the blade guard fixing plate.
CAUTION!
