ASSEMBLY & SET UP
A. Stand Setup
1. The Saw and Stand are ready to use. Simply unfold it as shown below.
2. Place the saw frame on the stand and tighten the stand knobs for safety. (See
Diagram 1) You may need to move or remove water tray to easily secure safety knobs to
stand frame.
B. Installing the Motor assembly
Step 1: Install the Motor Frame Assembly into the Motor Support Arm. (See Diagram 2)
Step 2: Pre-fix the Motor frame red locking knob into the hole provided, as shown.
This knob is used to also fine-tune the alignment of the motor frame assembly.
Step 3: Remove rubber cap to expose hex nuts. Firmly drive the three HEX bolts into
the Motor Support Arm with Allen Key provided and secure the Motor frame
locking knob.
Step 4: Place rubber cap back over hex nuts.
C. Installing the 4 in. Caster and Cable Collecting Hanger
1. Installing Upper Casters: Secure the 4 in. Casters at the two ends of the Base Frame
with HEX bolts & Nuts, as shown. (See Diagram 3)
2. Installing Cable Collecting Hanger/ Tool Caddy: Secure the Hanger onto the Motor
Support Arm with 2 bolts. (See Diagram 4) Place 2 spanners in hanger and place Allen
Key in opening provided.
D. Diamond Blade Installation
Step 1: When installing the blade, separate the two water feed
hoses inside the blade guard to allow the blade to sit
between them (see diagrams at right).
Step 2: Lift the blade guard and lock in place with the knob holding the blade guard.
Step 3: Hold the blade lock nut with the provided 23 mm spanner and also hold the blade
shaft with the other provided 10 mm spanner. At the same time, please move the
spanners upward to loosen (See Diagram 5) or move downward to tighten (See
Diagram 6) in order to open and close the blade shaft nut & outer flange. Then, -
attach and secure the blade onto the blade shaft, keeping the inner flange in place.
Place the blade between the two water tubes in the back of
the bladeguard.
Step 4: Replace the blade guard to its original position and tighten knob.
Step 5: To remove or change the blade, just reverse the Installation steps.
Diagram 1
Diagram 6
Diagram 5
Diagram 4
Diagram 3
The following is step-by-step installation and operation instruction manual.
Please read the information thoroughly prior to using your tile saw.
CAUTION!
Diagram 2
- 6 -
