RIP GUIDE
Straight Cuts
1. Adjust the 45/90 degree rip guide to 90 degree and position it the desired
distance from the blade. (See Diagram 13)
2. Lean the cutting material against the rip guide and back measurement rail.
3. Loosen the slide tube locking knob. (See Diagram 14)
4. Make a straight cut by pushing the cutting table toward the cutting head.
(See Diagram 13)
Diagonal Cuts
1. Adjust the 45/90 degree rip guide to 45 degree and position it the desired
distance from the blade.
2. Position the cutting material against the rip guide and back measurement rail.
3. Loosen the slide tube locking knob. (See Diagram 14)
4. Make a diagonal cut by pushing the cutting table toward the cutting head.
(See Diagram 15)
Plunge Cuts
1.
Turn off the power.
2.
Position the cutting material against the rip guide and back measurement rail.
3.
Loosen the slide tube locking knob. (See Diagram 14)
4.
Loosen the Motor Head Adjustment lever on the spring (See diagram 16)
support, to release the cutting head.
5.
Bring motor head to the highest position.
6.
Push the cutting table to the desired position where the blade is over the tile at
the point you want to start the cut-out.
7.
Tighten the slide tube locking knob to a fixed table position.
8.
Turn the saw on.
9.
Slowly push the blade down into the tile to achieve the plunge internal cut you
desire. (See diagram 17)
10. After each cut, turn the motor off and turn the position of the tile to achieve
rectangle or square cut-outs.
Diagram 12
Diagram 13
Diagram 14
Diagram 15
Diagram 16
CAUTION!
Turn off the power before adjusting the tile saw
motor head for plunge cuts or angle cuts.
Motor head height
adjustment
lever
Adjustable Cutting Table Extension
The adjustable cutting extension table is for the support of large format tiles. Users
could adjust front and side extension to desired dimension. (See Diagram 10)
Cutting Tile and Stone
1. Before performing any cuts, check and ensure that the lowest point of the
Blade is no more than 5 mm below the table top. (See Diagram 11)
2. Move the Motor Head Height Adjustment Lever upward (See Diagram 12), to
adjust the head to a proper height below the table. Then lock the lever in the
down position.
RIP GUIDE
WARNING!
CAUTION!
SAW OPERATION
- 8 -
1. Do not adjust the saw without first turning off the motor. Failure to do so may result in serious injury to the operator.
2. Always keep the saw clear. Never put things on rail while cutting.
