Seite 4 von 11
Introduction
This document has to be read before startup the device first time. Otherwise damage on the device and
external connected devices can occur.
The signal names in squared brackets (
[ ]
) are the references to the CAN-matrix.
List of abbreviations
U:
Voltage
I:
Current
HS:
High-Side
LS:
Low-Side
LIM:
Limit
MAX: Maximum
MIN:
Minimum
REG: Regulator
COM: Commanded
Valid regulator-values
ULS_MIN:
0V
(CAN-error is set, if the value is out of the range.)
ULS_MAX:
600V
(CAN-error is set, if the value is out of the range.)
UHS_MIN:
0V
(CAN-error is set, if the value is out of the range.)
UHS_MAX:
750V
(CAN-error is set, if the value is out of the range.)
ILS_MIN:
0 to -400A
(CAN-error is set, if the value is out of the range.)
ILS_MAX:
0 to 400A
(CAN-error is set, if the value is out of the range.)
IHS_MIN:
0 to -400A
(CAN-error is set, if the value is out of the range.)
IHS_MAX:
0 to 400A
(CAN-error is set, if the value is out of the range.)
UHS_COM:
0 to 1024V
(0 to -1024V)
(The device doesn’t check this value. If the UHS_COM
value is higher than UHS_MAX or lower than UHS_MIN, the device
is going to regulate on the limiting-values.)
