33
New Brunswick Scientific Co., Inc.
User’s Guide
7.2
Continuous (Unlimited) Run
1. Press
SELECT
until the
RPM INDICATOR
is illuminated.
2. If the display indicates that the shaker is
OFF
, press the
START/STOP KEY
.
3. Press
either
V
(UP)
or
W
(DOWN) KEY
to enter
SET MODE
(the
SET INDICATOR
will
illuminate).
4. Set the speed by using the
V
or
W
KEY
until the desired setpoint is displayed.
Continued pressure on the
V
or
W
KEY
will cause the setting to change more rapidly.
NOTE:
The setpoint may be changed during a run without stopping the shaker by
following steps 1-4 above.
7.3
Checking Any Setpoint
1. Press
SELECT
until the desired indicator is illuminated.
2. Briefly press either the
V
or
W
KEY
to enter the
SET MODE
and display the current
setpoint.
CAUTION!
Holding the
V
or
W
for more than 0.5 seconds causes the speed setpoint
to change. Should this occur, resetting will be necessary.
7.4 Timed
Functions
The shaker may be programmed to automatically stop after a preset time period of 0.1 to
99.9 hours. There must be power to the shaker in order to set the timer, although a timed
run can be initiated while the unit is either stopped or operating.
To set the timer:
1. Press
the
SELECT KEY
until the
HRS INDICATOR
is illuminated.
2. Press
either
V
or
W
KEY
to enter the
SET MODE
and set the desired run time, between
0.1 and 99.9 hours.
If the shaker is stopped, skip to Step 5 below. If the shaker is already running:
3. Press
the
START/STOP KEY
. The shaker will stop and the display will read
OFF
.
4. Press
the
START/STOP KEY
again; the
TIME INDICATOR
will light and the shaker will
start the timed run.
