Page 94 of 110
© Brüel & Kjær Vibro
● C106834.002 / V06
Technical alterations reserved!
EN
If the VIBROCONTROL 18xx device is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired. The safety of any machine/system
incorporating the VIBROCONTROL 18xx device is the sole responsibility of the assembler of
the system.
To avoid fading of the text on the label, please try to keep the device out of direct sunlight.
The assembly may only be carried out in a de-energized state!
10.2 Terminal Connections
There is a risk of mismatch when setting up the connections. An incorrect connection can
destroy the device.
A label on the side of the VIBROCONTROL 18xx enclosure indicates the function of the terminals
of the device. The connection of all sensor inputs, analog and relay outputs and the power supply
is made through dedicated terminals.
Each monitoring system is equipped with six terminal blocks, each with 4-pin connections labeled
from 1 to 24.
Clamping area for terminals (gray):
For rigid cable / For flexible cable: AWG 24
Clamping area for terminals (orange):
For rigid cable / For flexible cable: AWG 24