Page 50 of 110
© Brüel & Kjær Vibro
● C106834.002 / V06
Technical alterations reserved!
EN
7.1
VIBROCONTROL 1870
–
4 Channels - Relative Shaft Vibration
Specific settings for VIBROCONTROL 1870
Relative shaft vibration
The configuration of the measuring parameters of the VIBROCONTROL 1870 can be carried out
with Compact Setup software:
Four vibration displacement sensors can be connected to monitor relative shaft vibration.
For setup of the sensors, the gap voltage needs to be adjusted within a range from -2 to -18 V DC.
Ideally the sensor positioning should be close to -10 V DC to allow maximum measuring range of
relative shaft vibration.
The GAP Calibration Assistant provides setup support with a graphical display:
The measurement results for the relative shaft vibration and corresponding GAP value are
displayed via tabs (results):